Toggle Side Panel
Close search

Forum Replies Created

  • David Palazini

    Member
    January 21, 2026 at 10:52 am in reply to: Imperial to Metric
    Points: 449
    Rank: UC2 Brainery Newbie UC2 Brainery Newbie Belt Rank

    on my printed document the scale of each drawing section is different. So if a measurement is 60 MM in one view I have to make another viewpoint scaled area for a different area. Which is the same as in Imperial. But I was looking for a way just set the scale. I think i got it on normal views It might say 1:2 so I do a 1mm = 2mm and it works. Just harder on 3d items.

  • David Palazini

    Member
    January 21, 2026 at 10:48 am in reply to: Imperial to Metric
    Points: 449
    Rank: UC2 Brainery Newbie UC2 Brainery Newbie Belt Rank

    I don’t know how to do that..

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .