Working in cutout areas

  • Working in cutout areas

    Posted by David Cutler on March 15, 2021 at 4:00 pm

    I find the “polygon cutout” tool very useful when I have small areas of different takeoff types inside of a larger area – such as concrete islands in an asphalt parking lot. I ran into an issue this morning though where I need to add multiple other area takeoffs into the cutout are (some sidewalk, some grass). Bluebeam wanted to fill the cutout automatically with the next area measurement that I needed to place in the area. The solution I came up with was to cut out the sidewalk area first, apply the sidewalk area markup to the cutout, then cutout the grass area as a second cutout followed by applying the grass area measurement. Ended up working out well in the end!

    David Cutler replied 3 years, 2 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.