• UC2 Bluebeam Technical Support

  Measurements snap at 45 and 90 degree angles

  Posted by UC2 Bluebeam-Support on May 31, 2023 at 6:28 pm

  Why do your measurement lines snap at 45 and 90 degree angles?

  It’s likely the the Snap Orthogonal option is enabled in the Measurements panel.

  
  

  To disable select Window -> Panels -> Measurements.

  Select the Measurements dropdown.
  

  Single left click the Snap Orthogonal option to disable it.

  If the issue continues, you can also check the snap settings by going to Revu -> Preferences -> General -> Grid & Snap.

  UC2 Bluebeam-Support replied 1 year, 6 months ago 1 Member · 0 Replies
• 0 Replies

Log In to Reply