Showing results for ‘area measurement’
Blog Posts
15 results-
Land Development Bluebeam Tools of the Trade
Land Development Bluebeam Tools of the… -
Part 1, The 4 Evolutionary Stages of Measuring in Revu – A guest post by Vince French of Vinic Surveying
For those who don’t know, there are FREE Forums here on the UC2 website I like to call… -
Bluebeam Revu For Interior Design
Visually appealing designs, Accurate Counts & Easy Install There is no better…
Pages
8 resultsForum Discussions
9 results-
Cannot edit control points on area measurement
Scratching my head on this one. Working on a site takeoff for paving. I’ve measured the area with my custom area tool in two sections. I went back to clean… -
Dynamic fill dependent on line width
This is a minor issue for most, I’m sure. While checking some custom column formulas that calculate area and perimeter of an ellipse, I created an ellipse and used dynamic… -
Please “Report an Issue” En Masse to Prod Bluebeam to Resolve Problem
Requesting support for mass “Report an Issue” bombardment of Bluebeam regarding a problem with Area Measurement tool. The problem: After placing an Area Measurement markup, any copy of the original…
Forum Replies
17 results-
I’ve found that at times the measurement variable works in a formula when the length doesn’t. I think it has to do with the units assigned to a length whereas…
-
Just curious, are you take-offs limited to lf and type of base, crown, casing, jamb extension, picture rail, chair rail, ect. and door count, type and size? Area of wood…
-
Area markup from tool chest would be great. I have a few dozen area tools for anything from flat, sloped (pitches 1 thru 12), barrel and elliptical ceilings, shutter area,…
Videos
2 results-
Premium Workshop – Custom Area Measurements
Hope you enjoy the Premium Tool Building Workshop. To view the premium content below… -
Calibrating Plan & Profile Drawings in Bluebeam Revu
Whether you’re designing roads, utilities (underground or above ground), grading,…